Utilitise
There are 3 working modes:
High, Medium, Low. to scroll through modes, press the power button. Press and hold the power button for 5 seconds to initiate automatic cleaning.
2.The LED indicator light turns yellow when the device is charging, green when it is done charging, green/yellow alternately when the device is in automatic cleaning mode.
3.The device will automatically shut off after the use of 20 minutes.
4.The device comes with a lithium battery built into the unit.
5. The mesh module can be replaced by user.
How to Use
1.Open the lid of the medicine container, fill with medicine or isotonic saline solution and close the lid. Note: max fill is 10ml , DO NOT overfill.
2.Attach accessories as needed (mouthpiece or mask).
For the mouthpiece, wrap lips around the accessory tightly.
For the mask：place it over both nose and mouth.
3.Press on the power button and select your needed working mode. Note: each mode will take different time to atomize all the liquid. For 5ml:
High Mode : take about ~15 minutes
Medium Mode: take about ~20 minutes
Low Mode : take about~ 30 minutes
4.Press the power button to start the device.
5.The mesh nebulizer is on blue light hows that it is working perfectly.
6.Press the power button again if the device turn off automatically after using 20 minutes.
7. The mesh module (if needed): remove the mesh module by rotating it anticlockwise and install the mesh module by rotating it clockwise, as shown in the previous picture.
CAUTION
* Please only use pure soluble liquid in this device, DO NOT use purified water, oil, milk, or thick liquid. The volume of atomization varies with the thickness of the liquid used.
* Make sure to clean the mesh insert after every use to, DO NOT ouch the mesh with your hand, brushes or any hard objects.
* DO NOT submerge the device or rinse with liquid, if liquid get in the nebulizer, make sure it fully dries before the next use.
* DO NOT place the device on hot surface.
* DO NOT turn on the device without liquid in the liquid compartment.
